ODrive Pro

from $229.00

Shown with enclosure or heat spreader plate: recommended, sold separately.

The ODrive Pro does not have a brake resistor driver and should hence be used with a battery or a regen clamp module.

USB and DC input may not be connected at the same time, unless you use a USB isolator.

Specifications Below

SKUs:
- With screw terminal: ODv44-ST
- Without screw terminal: ODv44

1 - $ 229.00
10 - $ 219.00
For 40+ please use the RFQ/Order form.
40 - $ 214.00
100 - $ 209.00

For larger volumes please contact us for OEM pricing.

Power pads:

Solder pads Screw terminal

Quantity:

Single 10-Pack

Quantity:

Add To Cart

The ODrive Pro meets the needs of your demanding robotics application, with:

Locking connectors for high reliability wire harness
Ultimate reliability and high performance in 5 x 6.5cm
Dual absolute encoder support for precise load positioning and instant cold starts
Up to 5kW peak, 3kW continuous power with appropriate cooling
Shared software architecture with all current generation ODrives, including Web GUI support

Features & Specs

Single-axis (controls 1 motor)
High performance servo control of BLDC, PMAC, and ACIM motors
Torque, velocity, position, and trajectory control modes
Sensorless speed control
12-56V Operation (58V max)
Up to 70A continuous, 120A peak current with heatsink and fan
Control over USB, UART (Isolated), STEP/DIR (Isolated), Analog Voltage, PWM (Isolated), and CAN (Isolated)

CAN 2.0B @ 1Mbps with simple protocol (CAN-FD Firmware Coming Soon)
On-board magnetic encoder: MA702
- High quality encoder magnet available here. Recommended gap to top of IC package: 1mm
Supports offboard quadrature, hall, SPI, SSI, and RS485 encoders. BiSS-C support coming soon.
Incremental encoders and hall sensors have on-board input filters
Isolated CAN, UART, Step/Dir and PWM control inputs
Locking IO connectors with a diverse and flexible feature set.